Mechanical Design
‑44‑
Figure 2‑19 Top view of the cabinet for T11 to T12 models
To install T11 to T12 models into the nine‑fold profile cabinet with the depth of 600
mm, bend the back mounting board inwards, as shown in "
Figure 2–20
"
on page 44
. However, if the cabinet with the depth of 600 mm has both front and back doors,
the AC drive cannot be installed in this kind of cabinet. Instead, install the AC drive
into the cabinet with the depth of 800 mm.
Figure 2‑20 3D of the T11 to T12 model cabinet
2. Fix the bottom mounting bracket in the nine‑fold profile cabinet.
Fix the mounting bracket to the base of the nine‑fold profile cabinet by using six M5
self‑tapping screws, as shown in "
Figure 2–21
"
on page 45
.
To Next Page
Loading...
