Mechanical Design
‑45‑
Figure 2‑21 Installation of the mounting bracket
Note
If the cabinet used by the customer is not a nine‑fold profile cabinet, the fixing holes of the
mounting bracket need to be drilled and assembled on site.
3. Assemble a guide rail (model: MD500‑AZJ‑A3T10) and mount the guide rail assem‑
bly to the cabinet.
a. Assemble the guide rail, as shown in "
Figure 2–22
"
on page 45
.
Figure 2‑22 Guide rail assembling
b. Align the two round holes at the front end of the guide rail with the screws of the
mounting bracket, and then lock the guide rail to the cabinet with two M6 nuts,
as shown in "
Figure 2–23
"
on page 46
.
To Next Page
Loading...
