5G INDOOR CPE FX2000 USER GUIDE 52
MAC Filter Tab
The MAC filter allows only selected devices to access the FX2000 network through DHCP. By default,
MAC filter is turned off.
Use this tab to turn the MAC Filter on and specify device access.
MAC Filter
To use the MAC filter, select the device(s) from the device list that you want to be allowed to connect
to the network through DHCP and move the MAC Filter ON/OFF slider to ON. Click Save Changes.
CAUTION! Turning on MAC filtering immediately disconnects all devices that are not included in the
filter from the network.
Device List
This list includes all devices currently connected to the FX2000.
Add New Device: Use this button to add a device to the device list, then enter the device name, MAC
address, choose whether to select the MAC Address Filter checkbox, and click Save Changes.
To delete a device from the list, select its Delete checkbox and click Save Changes.
To discard any unsaved changes and refresh the list, click Refresh List and Confirm.
To Next Page
Loading...
