5G INDOOR CPE FX2000 USER GUIDE 55
WAN Settings
NOTE: WAN settings are available only with Inseego Connect.
Use this page to enable and configure WAN keepalive. Keepalive allows for a persistent WAN
connection.
Enable WAN Keep Alive: If ON, keepalive verifies lookup addresses to check the Internet connectivity
on the WAN connection.
Lookup Address 1: Enter the first DNS IP address to verify the WAN connection.
Lookup Address 2: Enter the second DNS IP address to verify (if Lookup Address 1 does not respond
with keepalive acknowledgement (ACK)).
Lookup Address 3: Enter the third DNS IP address to verify (if Lookup Address 2 does not respond
with keepalive ACK).
Keep Alive Interval: Enter the desired number of seconds without receiving a valid packet before the
first keepalive verification occurs.
Number of Attempts: Enter the number of times to retry after verification failure for all three lookup
addresses.
Retry Interval: Enter the number of seconds between verification retries.
To Next Page
Loading...
