EasyManuals Logo

Inseego Wavemaker FX2000 User Manual

Inseego Wavemaker FX2000
78 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #53 background imageLoading...
Page #53 background image
5G INDOOR CPE FX2000 USER GUIDE 53
LAN Tab
This page provides settings and information about the FX2000 local area network (LAN). The LAN
consists of the device and all connected devices.
IPv4
IP Address: The IP address for your FX2000, as seen from the local network. Normally, you can use the
default value.
Subnet Mask: The subnet mask network setting for the FX2000. The default value 255.255.255.0 is
standard for small (class "C") networks. If you change the LAN IP Address, make sure to use the correct
Subnet mask for the IP address range of the LAN IP address.
MAC Address: (read-only) The Media Access Controller (MAC) Address for the Wi-Fi interface on your
FX2000. The MAC address is a unique network identifier assigned when a network device is
manufactured.
Turn on DHCP server: This checkbox turns the DHCP Server feature on or off. This should be left
checked. The DHCP server allocates an IP address to each connected device. NOTE: If the DHCP Server
is turned off, each connected device must be assigned a fixed IP address.
DHCP Lease Time: The number of minutes in which connected devices must renew the IP address
assigned to them by the DHCP server. Normally, this can be left at the default value, but if you have
special requirements, you can change this value.
Start DHCP Address Range at: The start of the IP address range used by the DHCP server. If the IP is
set on the client device, use an IP address outside of this DHCP range; if the IP address is set using an IP
reservation, it will usually be inside this range. NOTE: Only expert users should change this setting.

Other manuals for Inseego Wavemaker FX2000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Inseego Wavemaker FX2000 and is the answer not in the manual?

Inseego Wavemaker FX2000 Specifications

General IconGeneral
CategoryNetwork Router
Ethernet Ports2 x Gigabit Ethernet
5G Bandsn2, n5, n41, n66, n71, n77
4G LTE BandsB2, B4, B5, B12, B13, B14, B25, B26, B30, B41, B46, B48, B66, B71
Wi-FiWi-Fi 6 (802.11ax), Dual-band (2.4GHz & 5GHz)
SIM Card SlotYes, Nano SIM (4FF)
USB Port1 x USB 3.0

Related product manuals