5G INDOOR CPE FX2000 USER GUIDE 22
Settings Tab
You can use the default values as they appear on this tab, or can adjust them for your environment.
Wi-Fi
Use the Allow Wi-Fi devices to connect slider to turn Wi-Fi on or off. This selection affects primary
and guest networks. NOTE: If Wi-Fi is off, the only way to connect devices to the 5G Indoor CPE is with
an Ethernet cable.
Select Change connection limit to change the maximum number of devices allowed to connect to
your 5G Indoor CPE. Select a number and click Save Changes. The maximum number of connected
devices is 32.
Band Selection
Each network can be accessed over two bands: 2.4 GHz and 5 GHz:
• The 2.4 GHz band is supported by all devices with Wi-Fi and should be used by devices that are
a few years old or older. This band passes through walls better and propagates over longer
distances, so it may have a longer range.
• The 5 GHz band is best for newer devices. It offers better throughput, reduced interference and
faster data speeds, but does not pass through walls as well as the 2.4 GHz band.
NOTE: The guest network must be assigned at least one band before it can be turned on.
To Next Page
Loading...
