5G INDOOR CPE FX2000 USER GUIDE 26
Guest Network Tab
The Wi-Fi guest network allows you to segregate traffic to a separate network rather than share access
to your Wi-Fi primary network. Use settings on this tab to set up or change Wi-Fi guest network
information. Connected devices must use the Wi-Fi settings shown on this screen to connect to the
guest 5G Indoor CPE Wi-Fi network.
NOTE: To turn the Wi-Fi guest network on, you must select at least one band for Guest Network under
Band Selection on the Wi-Fi Settings tab and then select Save Changes.
Guest Network
Guest Network Name (SSID): Enter a guest network name (SSID) to set up or change the guest
network name. The name can be up to 32 characters long.
Security: Select an option for Wi-Fi security:
• WPA3/WPA2 Transition is the most secure method of Wi-Fi Protected Access and should be
used if possible for WPA2 and WPA3 compliant devices.
• WPA3 PSK can be used for WPA3 devices.
• WPA 3 Open Enhanced provides encryption and privacy on open networks that are not
password-protected, and can be used for WPA3 devices.
• WPA/WPA2 Mixed Mode can be used if some of your older devices do not support WPA2.
• WPA2 AES PSK can be used for WPA2 devices.
• Open allows others to monitor your Wi-Fi traffic and use your data plan to access the Internet.
NOTE: Avoid using this option.
Password: Enter a Wi-Fi password, or you can use the Generate New Password button.
To Next Page
Loading...
