Integra DTC-9.4 - Index Parts and Facilities; Front Panels

96 pages

Save Page as PDF

To Next Page

To Previous Page

Index parts and facilities

Here is an explanation of the controls and displays on the front panel of the DTC-9.4.

Front panels

Front door

Push here to open the front door.

Main Page

Before Using Important Safeguards2
Precautions3
Contents4
- Table of Contents4
Features6
Supplied Accessories7
Before Using this Unit7
- Connecting the Power Cord7
- Using the Remote Controller7
Setting up the Remote Controller8
- Insert Batteries8
- Characterizing the Remote Controller8
- Touch the Screen to Start9
Index Parts and Facilities10
- Front Panels10
- Front Panel Display12
- Rear Panel13
- Remote Controller14
Connecting to Audio/Video Equipment16
- Connecting Your Audio Components17
- Connecting Your Video Components18
Speaker Configuration and Placement22
- Ideal Speaker Configuration22
- Minimum Speaker Configuration for Surround Sound Playback22
- Speaker Placement22
Connecting Antennas23
- Assembling the am Loop Antenna23
- Connecting the am Antenna Cable23
- Connecting the Included Antennas23
- Connecting an FM Outdoor Antenna24
- Connecting an am Outdoor Antenna24
- Directional Linkage24
Connecting Devices Used in Zone 225
- When Using the ZONE 2 out Terminals25
- When Using the SURR BACK/ZONE 2 PRE out25
- Terminals25
Operating Components Not Reached by the Remote Controller Signals (IR IN/OUT)26
- If the Remote Controller Signal Does Not Reach the DTC-9.4 Remote Sensor26
- If the Remote Controller Signal Does Not Reach Other Components26
Miscellaneous Connections27
- Connections for Remote Control ( )27
- Connecting the Power Cords from Other Devices27
- RS232 Port27
- Connecting to Devices with Analog Multi Channel Output28
- Connecting to an External Device with 12V TRIGGER Terminal28
- Connecting Auxiliary Power Amplifiers with RCA Type Connector28
- Connecting Power Amplifiers with XLR Type Connector29
Connecting the Power30
- Turning on the Power30
- Turning on the Power from the Remote Controller30
- To Change the Display of the Input Source from TAPE to MD30
Enjoying Music or Videos with the DTC-9.431
- Basic Operation31
- Adjusting the Bass and Treble31
- Listening with Headphones31
- Changing the Listening Mode32
- Switching the Display33
- Using the Dolby Headphone Function33
- Adjusting the Brightness of the Front Display34
- Temporarily Changing the Speaker Output Levels34
- Using the Sleep Time (Remote Controller Only)34
- Temporarily Turning off the Sound34
- Changing the Audio Mode35
- Enjoying the Multichannel Output35
Listening to Radio Broadcasts36
- Tuning into a Radio Station36
- Listening to a Stereo Radio Station (FM Mode)36
- Presetting a Radio Station37
- Selecting a Preset Radio Station37
- Erasing a Preset Radio Station37
Recording a Source38
- To Record the Input Source Signal You Are Currently Watching or Listening to38
- To Record an Input Source Signal Different from that You Are Currently Watching or Listening to38
- Recording the Video from One Source and the Audio from Another39
Enjoying Music or Videos in the Remote Zone40
- Using the Buttons on the DTC-9.440
- Selecting an Input Source Using the Remote Controller41
- Adjusting the Volume for the Remote Zone41
How to Enjoy Net Audio42
- System Requirements42
- Connecting the DTC-9.4 to Your Ethernet Network43
- Enjoying Internet Radio44
- Playing a Music File Saved on the Audio Network Server45
How to Enjoy Net Audio (Configuring Various Settings)47
- Input Setup Menu (When Net Audio Is Selected as the Input Source)47
- Network Setup Menu47
- Troubleshooting for Net Audio49
- Specifications49
Setup Menu50
- Navigating through the Setup Menu51
Hardware Setup52
- IR in Setup Sub-Menu52
- Surr Back/Zone 2 Sub-Menu52
- Hardware Setup Menu52
Speaker Setup53
- 1 Speaker Setup Menu53
- Speaker Config Sub-Menu53
- Speaker Distance Sub-Menu54
- Level Calibration Sub-Menu55
- THX Audio Setup Sub-Menu56
Input Setup57
- 2 Input Setup Menu57
- Digital Setup Sub-Menu (When Net Audio Is Not Selected as the Input Source)57
- Multichannel Setup Sub-Menu (When Net Audio Is Not Selected as the Input Source)58
- Character Input Sub-Menu59
- Video Setup Sub-Menu59
- Intellivolume Sub-Menu60
- Listening Mode Preset Sub-Menu60
- Trigger Setup Sub-Menu60
Audio Adjust64
- 3 Audio Adjust Menu64
- Surround Speakers Sub-Menu64
- Tone Control Sub-Menu64
- Delay Sub-Menu65
- Sound Effect Sub-Menu65
- LFE Level Sub-Menu66
- Mono Sub-Menu66
- Theater-Dimensional Sub-Menu66
- Surround Sub-Menu67
- Enhanced 7/Orchestra/Unplugged/Studio MIX /TV Logic Sub-Menu68
- Logic Sub-Menu68
- THX Sub-Menu68
Preference70
- 4 Preference Menu70
- Volume Setup Sub-Menu70
- Headphones Level Sub-Menu71
- OSD Position Sub-Menu71
- OSD Setup Sub-Menu71
Using the Remote Controller72
- Adjust the Settings72
- Working with Modes73
- Selecting a Device74
Define the Brand of Your Device75
- Defining Brands by Searching77
Programming Buttons78
- Programming Control Panel Buttons78
- Programming Device Items79
- Programming Direct-Access and Left/Right Buttons79
Labeling Buttons and Menu Items80
- Labeling a Button80
- Labeling a Menu Item80
Adding and Moving Devices81
- Adding Devices81
- Adding Macros81
- Moving Menu Items81
Delete and Restore82
- Delete82
- Restore82
Recording Macros and Setting Timers83
- Recording Macros83
- Editing Macros83
- Setting Timers84
- Organizing Macros and Timers into Groups84
Using the Remote Controller with Radio Frequency85
- Changing the Remote Controller's RF IR Settings85
- Choosing Another Channel86
Additional Information87
- Chadedit87
- Optional Recharging Dock87
Faq88
Overview of Symbols89
Appendix Troubleshooting Guide90
- Power90
- Speakers90
- Fm/Am Tuner90
- VIDEO and AUDIO91
- Other91
- Remote Controller92
- If One of the Messages Shown below Appears93
Specifications94

Integra DTC-9.4 - Index Parts and Facilities; Front Panels

Table of Contents

Related product manuals