Integra DTC-9.4 User Manual

29
Miscellaneous Connections
Connecting power amplifiers with XLR type
connector
Connect your power amplifier to the PRE OUT jacks on the DTC-
9.4. If the jacks on your power amplifier are XLR (balanced) type
jacks, connect them to the jacks shown in the diagram given below.
2. non-inverting (+) 1. GND
3. inverting (-)
1. Surround back right/Zone 2
right speaker
2. Surround back left/Zone 2
left speaker
3. Subwoofer
4. Center speaker
5. Front right speaker
6. Front left speaker
7. Surround right speaker
8. Surround left speaker
Push
LEFTRIGHTCENTERSUBWOOFER
SURROUND
LEFT
SURROUND
RIGHT
SURR BACK / ZONE 2
LEFT
SURR BACK / ZONE 2
RIGHT
PRE OUT
3 8746521
Power amplifier
These jacks are for connecting power amplifiers. If the jacks on your
power amplifier are XLR (balanced) type jacks, connect them here.
The pin assignments for these terminals are shown below.
These pin assignments conform to the standards made by the Audio
Engineering Society. Check the instruction manual that came with
your power amplifier and verify that the input pin assignments are
compatible with those for the DTC-9.4.
1. Connecting the output terminal
Match the pins and insert the terminal until you hear a “click.”
Ensure that it is secure by gently pulling it.
2. Disconnecting tha output terminal
Pull out the cable (in the direction indicated by the arrow) while
holding down the connection cable button.
Note:
For connections when you enjoy music and video in the remote room
(Zone 2), see page 25.

Integra DTC-9.4 Specifications

General

Brand	Integra
Model	DTC-9.4
Category	Controller
Language	English