Integra DTC-9.4 User Manual

41
Enjoying music or videos in the remote zone
Adjusting the volume for the remote zone
When the remote zone (Zone 2) speakers are connected to an
amplifier connected to the SURR BACK/ZONE 2 PRE OUT
terminals, adjust the volume as shown below.
Using the front panel:
Press the Zone 2 Level / buttons on the front panel.
Using the remote controller:
Press the VOL / buttons on the remote controller.
Note:
When the remote zone (Zone 2) speakers are connected to the pre-
main amplifier that is connected to the ZONE 2 terminal of the
DTC-9.4, adjust the volume for the remote zone at the pre-main
amplifier.
Selecting an input source using the remote
controller
When using the remote controller, select Zone 2 in the Home menu
to display the Zone 2 operation menu.
Turning on the Zone 2 and putting it in the standby state
when the DTC-9.4 is in the standby state:
Tap the ON button.
Select an input source:
Press an input source button.
If you select Tuner of the input selector buttons, you can select a
preset channel using the CH +/– buttons.
Note:
Each time you press one of the Zone 2 buttons on the remote
controller, the Standby indicator on the DTC-9.4 flashes for five
seconds. During this time, you will not be able to perform operations
in the main zone using the remote controller.
VOL
+
–
CH
+
–
CH
VOL
MUTE
CONT
+
–
LIGHT
L
VOL
CH
+
/
–
ON
Input selector
buttons
Zone 2 Level /

Integra DTC-9.4 Specifications

General

Brand	Integra
Model	DTC-9.4
Category	Controller
Language	English