Integra DTC-9.4 - Remote Controller

To Next Page

To Previous Page

Index parts and facilities

Remote controller

–

VOL

MUTE

CONT

–

LIGHT

AV Amp (Select AV Amp on the Home menu)

(page 1/4)

Home menu

(page 2/4)

(page 3/4)

(page 4/4)

Main Page

Before Using Important Safeguards2
Precautions3
Contents4
- Table of Contents4
Features6
Supplied Accessories7
Before Using this Unit7
- Connecting the Power Cord7
- Using the Remote Controller7
Setting up the Remote Controller8
- Insert Batteries8
- Characterizing the Remote Controller8
- Touch the Screen to Start9
Index Parts and Facilities10
- Front Panels10
- Front Panel Display12
- Rear Panel13
- Remote Controller14
Connecting to Audio/Video Equipment16
- Connecting Your Audio Components17
- Connecting Your Video Components18
Speaker Configuration and Placement22
- Ideal Speaker Configuration22
- Minimum Speaker Configuration for Surround Sound Playback22
- Speaker Placement22
Connecting Antennas23
- Assembling the am Loop Antenna23
- Connecting the am Antenna Cable23
- Connecting the Included Antennas23
- Connecting an FM Outdoor Antenna24
- Connecting an am Outdoor Antenna24
- Directional Linkage24
Connecting Devices Used in Zone 225
- When Using the ZONE 2 out Terminals25
- When Using the SURR BACK/ZONE 2 PRE out25
- Terminals25
Operating Components Not Reached by the Remote Controller Signals (IR IN/OUT)26
- If the Remote Controller Signal Does Not Reach the DTC-9.4 Remote Sensor26
- If the Remote Controller Signal Does Not Reach Other Components26
Miscellaneous Connections27
- Connections for Remote Control ( )27
- Connecting the Power Cords from Other Devices27
- RS232 Port27
- Connecting to Devices with Analog Multi Channel Output28
- Connecting to an External Device with 12V TRIGGER Terminal28
- Connecting Auxiliary Power Amplifiers with RCA Type Connector28
- Connecting Power Amplifiers with XLR Type Connector29
Connecting the Power30
- Turning on the Power30
- Turning on the Power from the Remote Controller30
- To Change the Display of the Input Source from TAPE to MD30
Enjoying Music or Videos with the DTC-9.431
- Basic Operation31
- Adjusting the Bass and Treble31
- Listening with Headphones31
- Changing the Listening Mode32
- Switching the Display33
- Using the Dolby Headphone Function33
- Adjusting the Brightness of the Front Display34
- Temporarily Changing the Speaker Output Levels34
- Using the Sleep Time (Remote Controller Only)34
- Temporarily Turning off the Sound34
- Changing the Audio Mode35
- Enjoying the Multichannel Output35
Listening to Radio Broadcasts36
- Tuning into a Radio Station36
- Listening to a Stereo Radio Station (FM Mode)36
- Presetting a Radio Station37
- Selecting a Preset Radio Station37
- Erasing a Preset Radio Station37
Recording a Source38
- To Record the Input Source Signal You Are Currently Watching or Listening to38
- To Record an Input Source Signal Different from that You Are Currently Watching or Listening to38
- Recording the Video from One Source and the Audio from Another39
Enjoying Music or Videos in the Remote Zone40
- Using the Buttons on the DTC-9.440
- Selecting an Input Source Using the Remote Controller41
- Adjusting the Volume for the Remote Zone41
How to Enjoy Net Audio42
- System Requirements42
- Connecting the DTC-9.4 to Your Ethernet Network43
- Enjoying Internet Radio44
- Playing a Music File Saved on the Audio Network Server45
How to Enjoy Net Audio (Configuring Various Settings)47
- Input Setup Menu (When Net Audio Is Selected as the Input Source)47
- Network Setup Menu47
- Troubleshooting for Net Audio49
- Specifications49
Setup Menu50
- Navigating through the Setup Menu51
Hardware Setup52
- IR in Setup Sub-Menu52
- Surr Back/Zone 2 Sub-Menu52
- Hardware Setup Menu52
Speaker Setup53
- 1 Speaker Setup Menu53
- Speaker Config Sub-Menu53
- Speaker Distance Sub-Menu54
- Level Calibration Sub-Menu55
- THX Audio Setup Sub-Menu56
Input Setup57
- 2 Input Setup Menu57
- Digital Setup Sub-Menu (When Net Audio Is Not Selected as the Input Source)57
- Multichannel Setup Sub-Menu (When Net Audio Is Not Selected as the Input Source)58
- Character Input Sub-Menu59
- Video Setup Sub-Menu59
- Intellivolume Sub-Menu60
- Listening Mode Preset Sub-Menu60
- Trigger Setup Sub-Menu60
Audio Adjust64
- 3 Audio Adjust Menu64
- Surround Speakers Sub-Menu64
- Tone Control Sub-Menu64
- Delay Sub-Menu65
- Sound Effect Sub-Menu65
- LFE Level Sub-Menu66
- Mono Sub-Menu66
- Theater-Dimensional Sub-Menu66
- Surround Sub-Menu67
- Enhanced 7/Orchestra/Unplugged/Studio MIX /TV Logic Sub-Menu68
- Logic Sub-Menu68
- THX Sub-Menu68
Preference70
- 4 Preference Menu70
- Volume Setup Sub-Menu70
- Headphones Level Sub-Menu71
- OSD Position Sub-Menu71
- OSD Setup Sub-Menu71
Using the Remote Controller72
- Adjust the Settings72
- Working with Modes73
- Selecting a Device74
Define the Brand of Your Device75
- Defining Brands by Searching77
Programming Buttons78
- Programming Control Panel Buttons78
- Programming Device Items79
- Programming Direct-Access and Left/Right Buttons79
Labeling Buttons and Menu Items80
- Labeling a Button80
- Labeling a Menu Item80
Adding and Moving Devices81
- Adding Devices81
- Adding Macros81
- Moving Menu Items81
Delete and Restore82
- Delete82
- Restore82
Recording Macros and Setting Timers83
- Recording Macros83
- Editing Macros83
- Setting Timers84
- Organizing Macros and Timers into Groups84
Using the Remote Controller with Radio Frequency85
- Changing the Remote Controller's RF IR Settings85
- Choosing Another Channel86
Additional Information87
- Chadedit87
- Optional Recharging Dock87
Faq88
Overview of Symbols89
Appendix Troubleshooting Guide90
- Power90
- Speakers90
- Fm/Am Tuner90
- VIDEO and AUDIO91
- Other91
- Remote Controller92
- If One of the Messages Shown below Appears93
Specifications94

Integra DTC-9.4 - Remote Controller

Table of Contents

Related product manuals