BIOS Architecture Intel® Server Board SE7520BD2 Technical Product Specification
56 Revision 1.3
ECC Event Logging Disabled
Enabled
Enables or Disables ECC Event Logging. Grayed out if "Critical Event
Logging" option is disabled.
PCI Error Logging Disabled
Enabled
Enables or Disables PCI Error Logging. Grayed out if "Critical Event
Logging" option is disabled.
FSB Error Logging Disabled
Enabled
Enables or Disables Front-Side Bus Error
Logging.
Grayed out if "Critical Event
Logging" option is disabled.
Hublink Error Logging Disabled
Enabled
Enables or Disables Hublink Error Logging. Grayed out if "Critical Event
Logging" option is disabled.
3.2.9 Exit Menu
Table 34. BIOS Setup, Exit Menu Selections
Feature Options Help Text
Exit Options
Save Changes
and Exit
N/A Exit system setup after saving the changes.
F10 key can be used for this operation.
Discard
Changes and
Exit
N/A Exit system setup without saving any changes.
ESC key can be used for this operation.
Discard
Changes
N/A Discards changes done so far to any of the setup questions.
F7 key can be used for this operation.
Load Setup
Defaults
N/A Load Setup Default values for all the setup questions.
F9 key can be used for this operation.
Load Custom
Defaults
N/A Load custom defaults.
Save Custom
Defaults
N/A Save custom defaults
3.3 Other BIOS Configuration Utilities
3.3.1 Logo Update Utility
TBD
3.3.2 Flash Update Utility
To perform a Floppy Update:
1. Boot the system and press <F2> to run BIOS Setup. Write down any custom BIOS
settings for the system.
2. Insert a blank floppy diskette in drive A. Note: All data on floppy diskette will be
destroyed.
3. Run floppy.exe to create an Update BIOS floppy disk found at:
4. http://support.intel.com/support/motherboards/server/se7520bd2.
5. Boot system with the Update BIOS floppy disk.
6. When the BIOS flash update is complete, a message will display that the operation is
complete.
7. Next, power cycle the system.
To Next Page
Loading...
Need help?
General
