Intellian i3 - Operating the ACU - Antenna Parameters; Setting the Antenna Parameters

34 i3/i4 Satellite Antenna System – Install and User Manual
SAVE ?
YES NO
19. Press YES to save the input information.
Press NO to can cel and retu rn to main setup
mode.
VERIFY : DVB DECODE
PREV SELECT NEXT
VOLTAGE: AUTO
PREV SELECT NEXT
16. Select the verification method
1)
of tracking
satellite.
PREV – Shows previous method.
SELECT – Set the displayed method.
NEXT – Shows next method.
DISEQC: ONLY 22KHZ
PREV SELECT NEXT
18. Select the DISEQC method
3)
(AUTO recommen ded)
1) Verification method
SIGNAL – use only signal level for tracking
DVB LOCK – use only DVB Lock signal for tracking
DVB DECODE – verify satellite using DVB decoding method for tracking
DSS DECODE – decode only DSS Lock signal for tracking
2) Voltage supply method
AUTO- change voltage to LNB by IRD voltage
ONLY 13V – always supply 13V to LNB
ONLY 18V – always supply 18V to LNB
3) DISEQC method
AUTO – change signal to LNB by IRD DISEQC
ONLY 0KHZ – always supply 0kHz to LNB
ONLY 22KHZ - always supply 22kHz to LNB
HOR HIGH NID 0x0003
- INPUT +
15. Input the network ID (NID) for horizontal high
band.
17. Select the voltage supplymethod
2)
to LNB
(AUTO recommen ded )