Intellian i3 - Page 39

Operation Using the ACU 35
Setting the Antenna Parameters
It is not recommended for a novice at satellite service to use this mode.
Consult Intellian for changing antenna parameters.
SETUP MODE?
YES NO
SET SAT PAIR ?
PREV YES NEXT
PARAM: SCAN OFF
PREV YES NEXT
x3
SET ANT PARAMETER?
PREV YES NEXT
WRS LEVEL : 0500
- INPUT +
SATNAME : DTV101
- INPUT +
SAVE ?
YES NO
1. Press YES to en ter setup mode.
4. Select the PARAM
1)
– SCAN OFF
PREV – Shows previous parameter.
SELECT – Set the displayed parameter.
NEXT – Shows next parameter.
Press ENTER to move to next screen.
5. Input the WRS LEVEL.
+increases the value. – decreases the value.
Change the underscored digit using the +/- buttons.
Press INPUT to accept the value and move to next
digit. Press BACK to move to previous digit.
Press ENTER to move to next screen.
6. Press YES to save the input information.
Press NO to can cel and return to main setup mode.
2. Press NEXT three times to enter set antenna
parameter mode.
3. Press YES to set antenna parameter.