Intellian i3 - Operating the ACU - LNB Frequency Settings; Setting the LNB Local Frequency (Case 2)

Operation Using the ACU 37
Setting the LNB local frequency
It is possible to select a local frequency from ACU. It is not recommended for
a novice at satellite service to use this mode.
CASE 1. Single band LNB is used.
SETUP MODE?
YES NO
SET SAT PAIR ?
PREV YES NEXT
SAVE ?
YES NO
x4
SET LOCAL FREQ?
PREV YES NEXT
LOCAL FREQ: #####MHz
- INPUT +
LNB TYPE : SINGLE
PREV SELECT NEXT
1. Press YES to enter setup mode.
2. Press NEXT four times to enter set local frequen cy
mode.
3. Press YES to set local frequency.
4. Select the LNB Type
1)
–SINGLE.
PREV – Shows previous LNB type.
SELECT – Set the displayed LNB type.
NEXT – Shows next LNB type.
Press ENTER to move to next screen.
5. Input the local frequency of LNB.
+increases the value. – decreases the value.
Change the underscored digit using the +/-
bu ttons. Press INPUT to accept the value an d
move to n ext digit. Press BACK to move to
previous digit. Press ENTER to move to next
screen.
6. Press YES to accept the data.
Press NO to can cel and return to main setu p mode.