Interlogix NX-595E User Manual

20 NX-595E User Manual
Menu 2 - System Control
2.1 Security System Status


2.2 Partition Control
 2.2.1 To turn off
 2.2.2 Away arm
 2.2.3 Stay arm
 2.3 To Control Zone Bypass
 2.4 Event History
Partition Control – Single Partition
Disarming: To turn your security system Off, from either the Away or Stay arming
modes.
Away Arming: To turn your security system On when you are leaving the
premises
Stay Arming: To turn your security system on when you are staying in the
premises, this will automatically bypass pre programmed zones and arm others.
Mainly utilized for arming just the perimeter of the premises.
Disarm – Single partition system
How to: Disarm a single partition system
Step Example: Disarming
1.
[PIN] Call the NX-595E via an offsite touch-tone phone to begin the session.
2.
Press [2] for system control menu.
Press [2] for partition control menu.
Press [1] to turn off.
3.
1
st
star, moves back to system control menu.
2nd star, moves back to main menu.
# Disconnects session.
Away Arm – Single partition system
How to: Away Arm a single partition system
Step Example: Away Arm
1.
[PIN] Call the NX-595E via an offsite touch-tone phone to begin the session.
2.
Press [2] for system control menu.
Press [2] for partition control menu.
Press [2] two to set in the away mode.
3.
1
st
star, moves back to system control menu.

Interlogix NX-595E Specifications

General

Quantity	1
Compatibility	V2 (NX-4, NX-6, NX-8, NX-8E, NX-7, NX-9, NX-10, NX-11)
Operating temperature (T-T)	0 - 49 °C

Weight and Dimensions

Depth	90 mm
Width	220 mm
Height	45 mm
Weight	130 g
Dimensions (WxDxH)	220 x 90 x 45 mm