ZeroWire Reference Guide 25
Siren At System Away or Disarm
If enabled, the ZeroWire will activate the built-in siren briefly, every time the last
area in the system is set in away mode or when the first area is disarmed. To
individually enable this function by area, leave this function disabled in this
section, and enable the “Siren at Away/Disarm” in Menu 4 – Areas.
Siren At End Of Exit
If enabled, the ZeroWire will activate the built-in siren briefly every time the
system is set in away mode and the exit delay expires.
Siren At Arm Report
If enabled, the ZeroWire will activate the siren output every time the system is set
in away mode with a key-switch or wireless keyfob, the exit delay expires and a
successful system arm report is completed. The sirens will chirp three times.
Service and Test Options
Status Email Intervals
If enabled, the ZeroWire will report a system status email via one or more email
channels. The number entered for Status Email Interval is the number of days
between status reports. For example entering a 7 will cause a report to be sent
every 7 days.
The interval starts from either the first time you program an interval in here or
when it is powered up.
This is sent via the System Event Reporting – Reporting Channels.
Status Email Time
The status email time sets the time of day that the status email will report. This is
set as 24-hour time in hours and minutes.
Service Phone Number
When a system fault is present, the Status key will be red. Pushing the Status
key will announce this number to the end-user. Typically this is the contact
number of the installation company.
Status
This menu provides diagnostic information on the connection status of the
ZeroWire.
LAN Status
Status of the connection to the Local Area Network.
LAN Media
When connected to the Local Area Network whether this is via Ethernet or WiFi.
To Next Page
Loading...
Need help?
General
