32 ZeroWire Reference Guide
Exit Time 1
Whenever an area is turned on, it will start an Exit 1 timer. Entry 1, Entry 2, and
Handover zone types will not create an alarm while an Exit 1 timer is running.
Entry Time 2
Entry time 2 is used to time the entry delay when an entry delay is started by an
entry 2 zone type
Exit Time 2
When the Exit 1 timer expires it will start the Exit 2 timer. Entry 2 zones will not
create an alarm while an Exit 2 timer or an Exit 1 timer is running.
Stay Entry Time
The stay entry time is the entry warning time that applies to all zones armed in
the stay mode. This stay entry time does not apply to fire zone types.
Area Options
Arm/Disarm Report
If enabled, this area will send open and close reports via one or more
appropriately configured channels.
Quick Away
If enabled, this area can be armed in away mode via a single away mode key
press. When area is armed via quick away mode, the closing user number is the
default user of 999.
Arm In Stay If No Exit
If enabled, arms the area in stay mode automatically after the exit timer expires
and no Entry/Exit zones are tripped.
Quick Stay Mode Disarm
If enabled, this will allow the stay mode to be disarmed by pressing the stay key
on the keypad. This is only possible if the is no alarm active and the stay entry
delay is not running.
This is a convenience feature avoiding the need to enter the PIN to disarm from
stay mode.
Siren Chirp Away
If enabled, the ZeroWire will activate the built-in siren every time the system is
set in away mode or disarmed with a key-switch or wireless keyfob.
Siren Chirp Stay
If enabled, the ZeroWire will activate the built-in siren output briefly every time
the system is set in stay mode with a key-switch or wireless keyfob.
To Next Page
Loading...
Need help?
General
