70 ZeroWire Reference Guide
Menu 15 - Zone Types
Zones can be programmed to be one of 32 different zone configurations. Zones
are fully configurable in the ZeroWire panel. These features are considered
advanced programming and should only be changed with a thorough
understanding of the operation of each bit.
Zone type profiles can also change depending on whether the areas they are in
are armed or disarmed. This provides the ultimate flexibility in panel
programming.
Zone Type Number
The ZeroWire can support a total of 32 Zone Types. Each Zone Type is identified
by a unique number, which cannot be altered, and remains as the key reference
for each Zone Type.
Zone Type Name
Each Zone Type can be configured with a custom 32 character name. The name
is displayed wherever a Zone Type is referenced on the ZeroWire system.
Area Armed
Zone Attribute
See descriptions below; this is how the zone will behave when the partition it is in
is armed.
Disabled: Zone is disabled.
Entry 1: Zone will follow entry/exit timer 1.
Entry 2: Zone will follow entry/exit timer 2.
Handover: Instant alarm type unless an entry zone if tripped first.
Instant: Zone goes into alarm as soon as it is tripped.
Trouble Zone: Zone reports zone trouble alarm and keypad sounds
trouble beeps when tripped.
Fire: Smoke detectors must be wired Normally Open. A short on a fire
zone will create an alarm condition when the system is armed or
disarmed. An open will create a Trouble condition that is always reported
for this zone type, regardless of the Zone Trouble reporting option. After a
fire activation, use the keypad to clear & reset fire detector by pressing
Menu – 7 – Zone Reset.
Holdup delay: When tripped, starts the holdup timer, if the timer is
reached then a hold up alarm is sent.
Holdup reset: When this zone is tripped, the holdup timer is stopped.
To Next Page
Loading...
