64 ZeroWire Reference Guide
Stay Arm Area Group
This controls what areas can be stay armed.
Permission Options
Remote Access
Enables and disable remote web access to the permission. If this is not enabled,
a user will not be able to access the web interface directly or via a smartphone
app.
Duress Code
Designates this user as a duress code, whenever this code is entered on the
ZeroWire keypad a duress message is sent.
Reset System Alarms
When System Option - System Alarm Latch is enabled, system alarms include
panel box tamper can only be reset by a user with this permission. Users without
this permission will be able to arm and disarm areas as normal, but system
alarms will stay latched.
Auto Un-Bypass
When enabled, a bypassed zone will be reset when disarming. When disabled,
the zone will remain bypassed even after the system has been disarmed.
Disarm Area In Alarm
When disabled, this user will not be able to disarm and reset an area in alarm.
Even if the user has permission in their Disarm Area Group, this option will
override disarm authority.
Area Type Override
Applies to non-standard area types 'Time Disarm' 'Man Down' 'Guard Tour'.
When set, disables the feature for the user.
Disarm Action Trigger
When enabled, this user will trigger the Action trigger event “User Disarm
Trigger” when disarming an area, used for programming actions.
Arm Action Test
When enabled, this user will trigger the Action trigger event “User Arm Trigger”
when arming an area, used for programming actions.
Report Arm/Disarm
Where a system is already configured to send Arm-Disarm reports this option
allows a user to NOT send a report. When enabled, the reports will be sent.
When disabled, reports will not be sent.
To Next Page
Loading...
