ZeroWire Reference Guide 43
Auto Test Time
Enter the time at which the automatic test report should be sent. This should be
in 24-hour format. For example 18:00
IP Configuration
IP Host Name
A text label assigned to the ZeroWire communicator so you do not have to
remember the IP Address. Enter //[IP Host Name] in a Microsoft Windows web
browser to access the ZeroWire Web Server.
Note this only works on local LAN and with Microsoft Windows PC, or an Apple
device with the .local extension. Does not work remotely over the internet.
IP Address
The IP address assigned to the ZeroWire communicator to enable it to connect
on to the local LAN. This will allow you to access the embedded web server from
a web-enabled device to program and view the status of the system. It is also
used for alarm reporting.
Gateway
If required, the IP address of the router which is needed when remote IP
communications are used
Subnet
The subnet mask for the network.
For example, 255.255.255.0 is the network mask for 192.168.1.0/24
Primary DNS
The IP address of the Primary Domain Name Server. The DNS is used to
translate host names for time servers and UltraSync servers.
Secondary DNS
The IP address of the Secondary Domain Name Server, used if the Primary DNS
is not available.
WiFi SSID
The Service Set Identifier, uniquely identifies the WiFi network and allows
devices to connect to it.
WiFi Security Type
Select the security protocol for the network. Options available include: None,
WPA2, WPA, WEP, WEP 128, none.
To Next Page
Loading...
