Interlogix ZeroWire - Page 45

ZeroWire Reference Guide 45
• Enable UltraSync: This is an automatic feature of ZeroWire. It is
recommended you leave this setting on. Enable this option to allow ZeroWire
to send email reports via the UltraSync servers. This is independent of the
Web Access Passcode which when set to 00000000 will prevent the
UltraSync + app from connecting. If any channel is set to Email format
reporting, then ZeroWire will override ignore this setting and allow email
reporting via UltraSync cloud servers. If you wish to prevent connections to
the ZeroWire cloud servers, then uncheck this option and do not use the
UltraSync reporting format.
Features
Email Reports
UltraSync + app
Enable UltraSync = OFF
Web Access Code = 00000000
No
No
Enable UltraSync = OFF
Web Access Code = not 00000000
Yes
Yes
Enable UltraSync = ON
Web Access Code = 00000000
Yes
No
Enable UltraSync = ON
Web Access Code = not 00000000
Yes
Yes
• Enable WiFi, Disable Ethernet: Enabling this option will cause the ZeroWire
to use WiFi as the primary medium to connect to the Internet. Disabling this
option will switch the connection mode to Ethernet. If switching between WiFi
and Ethernet modes, logout of webpage, keypad programming, and app to
end current session. This allows the panel to reconnect on the new mode.
WiFi and Ethernet cannot be enabled simultaneously.
Radio Configuration
These are the credentials used by the cellular radio module, if installed, to
connect to the mobile network. Check with your service provider for the correct
settings.
• GPRS User Name
• GPRS Password
• APN
Remote Access
Panel Device Number
A number from 0 to 4,294,967,295 that must be entered in to the desktop
software for remote access to take place.