Interlogix ZeroWire Reference Guide

ZeroWire Reference Guide 61
Menu 10 - Devices
This menu allows you to program devices connected to the ZeroWire system.
The specific menus that appear are dependent on the device(s) you connect and
may not match this section exactly.
System Devices - Control
Control UID
Serial number of the ZeroWire.
Control Name
The name of the ZeroWire system.
Control Info
Version information about the ZeroWire including firmware, voice, web, and MAC
address.
Control Outputs
The ZeroWire has 2 on-board outputs which can be programmed to follow
actions.
• Output Name: Each output can be configured with a custom 32 character
name.
• Action Assignment: The output will activate while the selected action state
is true. If the action state becomes false then the output will deactivate.
• Schedule Number: If a schedule is entered here then the output will only be
active when the schedule is valid. If no schedule is entered then the output
will always function.
• Invert: Invert the output.
Interlogix Transmitters
Transmitter Number
Serial Number
User: By default all keyfobs are reported as user 999. To enable individual
keyfob reporting, assign a user number here.
Options: Allows the installer to configure options for wireless transmitters
including:
• Tamper – enable the tamper, for keyfobs this is the dual press of the
first two buttons.
• Police – enable the manual police button on four button keyfobs.
• Auxiliary – enable the manual auxiliary, for four button keyfobs this is
the dual press of the last two buttons.

Interlogix ZeroWire Specifications

General

Brand	Interlogix
Model	ZeroWire
Category	Security System
Language	English