Intermec CN3 Series - Page 108

Chapter 3 — Configuring the Computer
92 CN3 Series Mobile Computer User’s Manual
3 For Association, choose Open, WPA, WPA2, or Network
EAP.
4 For Encryption, choose TKIP or AES if you selected WPA2
for association, or WEP or CKIP if you selected Network
EAP for association.
5 For Username, type a unique username for this protocol.
6 In the Password field, type a unique password for this
protocol.
7 Select Prompt for password to have the user enter this
password each time to access the protocol, or select Use
following password to use the protocol without entering a
password each time you use the CN3.
8 (Optional) Tap Get Certificates to obtain or import server
certificates. For help with certificates, see “Loading a
Certificate” on page 99.
9 Tap Additional Settings to assign an inner TTLS
authentication, inner EAP, and set options for server
certificate validation and trust.
10 From the Inner TTLS Authentication list, choose PAP,
CHAP, MS-CHAP, MS-CHAP-V2, PAP/Token Card, or
EAP.
11 If you select EAP for the inner authentication protocol, select
an inner EAP protocol from the Inner EAP list.
12 Check Validate Ser ver Certificate to verify the identity of the
authentication server based on its certificate when using
TTLS.
13 Tap Root CA, select a root certificate, and then tap OK.
14 Enter the Common Names of trusted servers.
15 For Anonymous EAP-TTLS Name, type an outer identity to
protect your login name or identity.
16
Tap OK.