Intermec CN3 Series

Chapter 3 — Configuring the Computer
CN3 Series Mobile Computer User’s Manual 93
Configuring LEAP Security With Profile Wizard
LEAP is the Cisco Lightweight version of EAP.
To configure LEAP security
1 In the Profile Wizard, select the Security page.
2 For 8021x Security, choose LEAP.
3 For Association, choose Open, WPA, WPA2, or Network
EAP.
4 For Encryption, choose TKIP or AES if you selected WPA2
for association, or WEP or CKIP if you selected Network
EAP for association.
5 For Username, type a unique username for this protocol.
6 In the Password field, type a unique password for this
protocol.
7 Select Prompt for password to have the user enter this
password each time to access the protocol, or select Use
following password to use the protocol without entering a
password each time you use the CN3.
8 Tap OK.