Intermec CN3 Series

Chapter 1 — Using the Computer
18 CN3 Series Mobile Computer User’s Manual
.
The CN3 has a built-in vibrate feature that enables you to receive
scanner feedback despite the noise level. When enabled, the CN3
vibrates when the scanner performs a good read or when the
phone receives a call.
To enable the vibrate feature
1 Tap the Volume ( ) icon at the top of the screen.
2 In the Volume adjust box, tap Vibrate.
Changing the Volume of the Rear Speaker
Way to Adjust Volume Procedure
Tap the Volume ( ) icon
in the navigation bar.
Use the stylus to move the volume slider
up or down for the computer. You can
also turn the volume on or off and
choose to use Vibrate mode.
Use Intermec Settings. From the Start menu, choose Settings >
the System tab > Intermec Settings. Go
to Device Settings > Beeper > Volume.
Select the setting you prefer and save
your changes before exiting. For help, see
“Configuring the Computer With
Intermec Settings” on page 48.
Press the side volume
control.
Press the top of the side volume control
to turn the volume up. Press the bottom
of the side volume control to turn the
volume down.
Note: For detailed information on the commands available in
Intermec Settings, see the Intermec Computer Command Reference
Manual (P/N 073529) available from the Intermec web site.