Chapter 3 — Configuring the Computer
CN3 Series Mobile Computer User’s Manual 81
Configuring WPA Security With Funk Security
Use these procedures to set WPA-802.1x, WPA2-802.1x, WPA-
PSK, or WPA2-PSK security on your CN3 with Funk security.
To configure WPA-802.1x or WPA2-802.1x with Funk security
1 Make sure you have configured the communications and
radio parameters on your CN3.
2 Make sure you have selected Funk as your security choice.
3 Open Intermec Settings.
4 Choose Communications > 802.11 Radio > Funk Security
> Profile.
5 For Association, choose WPA or WPA2 and press Enter.
Encryption automatically defaults to TKIP if you are using
WPA. Encryption automatically defaults to AES if you are
using WPA2.
6 For 8021x, choose TTLS, PEAP, EAP-FAST, or TLS and
press Enter.
If you choose TTLS or PEAP:
a For Prompt for Credentials, choose Enter credentials
now.
b Select User name and type your user name.
c Select User Password and type a user password.
d For Validate Server Certificate, choose Yes.
If you choose TLS:
a Load a user and root certificate on your CN3. For help,
see “Loading a Certificate” on page 99.
b For Validate Server Certificate, choose Yes.
Note: You can use Prompt for credentials to troubleshoot
your connection to the network if you have problems.
Note: You must have the date on the CN3 set correctly when
you enable Validate Server Certificate.
To Next Page
Loading...
