Intermec EasyCoder 4420 - Page 149

Index
I-7
I
problems (
continued
)
printer operation, 4-3
protocols, C-3
hardware protocol, C-6
Multi-Drop, C-5
Polling Mode D, C-5
Standard, C-3
user-defined, C-6
XON/XOFF, C-4
Q
QR Code, A-10
quality
correcting uneven print, 5-3
optimizing and maintaining print, 5-3
quality problems, troubleshooting, 4-5
R
RAM, using efficiently, 5-13
ready, definition, G-7
Ready/Busy line, definition, G-7
removing the printer cover, 1-9
requirements
electrical, A-3
host, C-8
rest point, label, 6-10
ribbon specifications, A-5
roll media, loading, 1-10
rollers, cleaning, 3-8
RS-232, C-9
definition, G-7
null modem cable schematics, C-12
RS-422, C-9
cable schematics, C-13
definition, G-7
RS-485, C-9
definition, G-7
S
safety summary, ix
scan, definition, G-8
scannable, definition, G-8
schedule of maintenance, 3-3
selective transfer, 6-6
definition, G-8
self-strip, A-7
definition, G-8
sensitivity, definition, G-8
sensor
adjusting the label gap, 5-10
adjusting the label mark, 5-11
cleaning label, 3-12
serial interface, C-9
RS-232, C-9
RS-422, C-9
RS-485, C-9
serial port
configuration, 2-7
description, C-11
using to connect a PC to the printer, 2-4
serial, definition, G-8
setting the media sensitivity number, 1-17, 1-18, 1-20
settings, factory default, A-6
skip, definition, G-8
skipping labels, adjusting the printer to stop, 5-10
soft font, definition, G-8
software configuration label, printing, 1-18
specifications, printer, A-3 to A-5
speed, printing, A-5
stacked symbologies,
See
2D symbologies
Standard protocol, C-3
definition, G-8
symbologies
2D, A-9
Codabar, A-8
Code 11, A-8
Code 128, A-8
Code 16K, A-9
Code 2 of 5, A-8
Code 39, A-8
Code 49, A-9
Code 93, A-8
Data Matrix, A-10
EAN, A-8
Interleaved 2 of 5, A-8
Maxicode, A-10
MicroPDF417, A-9
PDF417, A-9
POSTNET, A-9
QR Code, A-10
UPC, A-9
symbology, definition, G-8
T
tear bar, cleaning, 3-8
terms, manual, xii
Test and Service mode
changing configuration commands from, 6-8
Data Line Print, 6-5
DIP switch settings, 6-4
entering, 6-3
exiting, 6-3
memory reset, 6-7
printing test labels, 6-5
selective transfer, 6-6
setting Emulation mode, 6-12
using forms adjust, 6-13
X forms adjust, 6-14
Y forms adjust, 6-15