Cd 39
Using Test and Service Mode
6-7
6
Using Memory Reset
Use memory reset if you want to return the printer to its default configuration or if you
need to increase the amount of memory available in the printer. You can also use
memory reset to clear pages and formats, user-defined characters and fonts,
configurations, tables, or all of these parameters.
To use memory reset
1. Turn off the printer.
2. Set the DIP switches to reset a portion or all of the memory by using the Test and
Service Mode DIP Switch Settings table on page 6-4.
3. Press and hold the Feed/Pause button while turning on the printer. The printer
prints out a hardware configuration test label.
4. Hold the Feed/Pause button down for 1 second. The printer resets a portion or all of
its memory.
5. To exit Test and Service mode, turn off the printer.
6. Reset the DIP switches to their original setting and then turn on the printer.
Note:
You can also use the Test and Service command (D) to reset all printer RAM.
To Next Page
Loading...
Need help?
General