EasyCoder 4420/4440 Bar Code Label Printer User’s Manual
1-6
Using the Front Panel LEDs for Troubleshooting
Over-Temperature If the printer overheats, the Alert LED flashes and the printer
stops. Do not try to troubleshoot or adjust the printer—just allow it enough time to cool
down and it will resume operation on its own. You should only encounter this problem
after extended print jobs.
Media or System Faults If the Empty/Pause or the Alert LED remains on, the printer
is experiencing a media or system fault. See Chapter 4, “Troubleshooting the Printer,”
for help in correcting the problem.
Using the Feed/Pause Button
The Feed/Pause button, located on the front panel of the 4420 or 4440 printer, performs
several functions depending on the mode of the printer.
Printer Mode You Want To What to Do
Idle Feed out one label or a
minimum specified amount
of media.
Press and release the Feed/Pause button.
Continuously feed media. Press and hold the Feed/Pause button. When
you release the button, the media stops
feeding.
Take the printer offline. Press the Feed/Pause button twice. Press the
button again to bring the printer online.
Printing Pause the printer. Press and release the Feed/Pause button. Press
and release the button again to resume
printing.
Cancel the current print
job.
Press and hold the Feed/Pause button until the
printer stops printing.
Turned on for the
first time
Print the hardware
configuration test label.
Press and hold the Feed/Pause button. See
“Printing the Hardware Configuration Test
Label” later in this chapter.
To Next Page
Loading...
Need help?
General