Appendix A — Specifications
PM4i Mid-Range Printer User’s Manual 123
Self-Adhesive Labels
Liner (b)
The backing paper must not extend more than a total of 1.6 mm
(0.06 in) outside the labels and should protrude equally on both side.
Recommended minimum transparency: 40% (DIN 53147).
Media Width Including Liner (a)
Measurement Value
Maximum 114.3 mm (4.50 in)
Minimum 25.0 mm (1.00 in)
Label Width Excluding Liner (c)
Measurement Value
Maximum 112.7 mm (4.43 in)
Minimum 23.8 mm (0.94 in)
Label Length (d)
Measurement Value
Maximum Dependent on SDRAM size
Minimum 8.0 mm (0.32 in)
Note: Under ideal circumstances, a minimum label length of 4 mm
(0.16 in) could be used. It requires the sum of the label length (d) and
the label gap (e) to be larger than 7 mm (0.28 in), that batch printing is
used, and that no pull back of the media is performed. Intermec does
not guarantee that such short labels will work, but it is up to users to
test this in their unique application.
Label Gap (e)
Measurement Value
Maximum 21.3 mm (0.83 in)
Recommended 3.0 mm (0.12 in)
Minimum 1.2 mm (0.05 in)
To Next Page
Loading...
