Chapter 1 — Using the Printer
PM4i Mid-Range Printer User’s Manual 23
Loading Media for Cut-Off Printing
You can install the automatic paper cutter option to cut off the
media. Cut-off printing can be used for non-adhesive continuous
stock and self-adhesive labels with liner (cut only liner between
labels). The cutter option:
• is designed for paper-based media with a thickness between
60 and 175 μm, roughly corresponding to a paper weight of
60 to 175 grams/m2 (basis weight 40 to 120 lb).
• should not be used to cut through labels, because the adhesive
sticks to the shears, which can damage the cutter.
• is held by a latch inside the media compartment and can be tilted
forward to facilitate loading media.
• has a switch that prevents it from operating when it is in the open
position.
• can be fitted with an optional tray for collecting cutoff labels.
• requires the front door to be removed.
You can also install an optional label taken sensor so that the next
copy in the batch is not printed until the current copy is removed. For
more information, see “Accessories for the Printer” on page 129.
To Next Page
Loading...
