Intermec PM4I - Configuring General Network Settings

Chapter 3 — Configuring the Printer
68 PM4i Mid-Range Printer User’s Manual
Configuring General Network Settings
Use the General network page to view the printer name, change
passwords, and set restrictions.
To configure general network settings
1 Click Network Admin > General.
2 View or update your settings.
3 Click Submit General settings.
Use the following table to understand the general network settings.
Odometer Count 1 The amount of media printed has reached a preset
amount, measured in meters or in number of labels.
The Delay repeat setting represents how often the alert
message will be sent when the preset value is reached.
Notification
Method
The method used to send an alert message. You can
choose from mail, SNMP-trap, or both.
Understanding the Alert Settings (continued)
Setting Description
Note: To enter a new password, you need to check the Set
password check box.
Understanding the General Network Settings
Setting Description
Printer Name The network identification name (WINS name) of the
printer. The default name is INTERMEC followed by
the last six positions of the MAC address.
System Location (Optional) The printer location.
System Contact (Optional) The printer administrator.
Set Password You must check this box if you want to change the
admin password.
Old Admin
Password
You need to enter the old password before you can
change the password.
New Admin
Password
The new password you want to use.