Intermec PM4I - IPL Default Configuration

Appendix B — Default Settings
PM4i Mid-Range Printer User’s Manual 137
IPL Default Configuration
Label taken sensor (LTS)
LTS adjust
LTS test
LTS value
N/A
N/A
10
Print Defines Parameters (continued)
Parameter Default Value
Ser-Com Parameters
Parameter Default Value
Baud rate 9600
Data bits 8
Parity None
Stop bits 1
Protocol XON/XOFF
COM Parameters
Parameter Default Value
USB keyboard US
Network Parameters
Parameter Default Value
IP selection DHCP+BOOTP
IP address N/A
Netmask N/A
Default router N/A
IPv6 selection Auto
IPv6 address N/A
Nameserver N/A
Nameserver6 N/A