Intermec PM4I - IPL Network Menu; IPL RFID Menu; IPL TestService Menu

Appendix C — Fingerprint and IPL Setup Menus
PM4i Mid-Range Printer User’s Manual 147
IPL Network Menu
IPL RFID Menu
IPL Test/Service Menu
NETWORK TYPE:
Wireless 802.11
DHCP RESPONSE:
UNICAST
IPV6 SELECTION:
MANUAL
IPV6 SELECTION:
DHCP
IPV6 SELECTION:
AUTO+DHCP
PARITY:
BOOTP
PARITY:
DHCP
PARITY:
MANUAL
SETUP:
NETWORK
NETWORK:
IP SELECTION
NETWORK:
IP ADDRESS
NETWORK:
NETMASK
NETWORK:
DEFAULT ROUTER
NETWORK:
IPV6 SELECTION
IP SELECTION:
DHCP+BOOTP
IP ADDRESS:
0.0.0.0
NETMASK:
0.0.0.0
DEFAULT ROUTER:
0.0.0.0
IPV6 SELECTION:
AUTO
NETWORK:
IPV6 ADDRESS
IPV6 ADDRESS:
0000::000:0000:0
NETWORK:
NAMESERVER
NETWORK:
NAMESERVER6
NETWORK:
DHCP RESPONSE
NETWORK:
MAC ADDRESS
NETWORK:
NETWORK TYPE
NAMESERVER:
0.0.0.0
NAMESERVER6:
00::0
DHCP RESPONSE:
BROADCAST
MAC ADDRESS:
nnnnnnnnnnnn
NETWORK TYPE:
Ethernet
Read_only
MODE:
DISABLE
SETUP:
RFID
RFID:
MODE
RFID:
TAGREAD
RFID:
TAGADJUST
RFID:
RETRIES
RFID:
VOIDTEXT
MODE:
ENABLE
TAGREAD: TAGADJUST:
+0
RETRIES:
1
VOIDTEXT:
VOID
RFID:
FIELDSTRENGTH
FIELDSTRENGTH:
100
Only displayed if an RFID module is installed.
Read-only Read-only
CONFIG:
NETWORK
CMD LANGUAGE:
Direct Protocol
CMD LANGUAGE:
Fingerprint
TEST LABELS:
PRINT QUALITY
SETUP:
TEST/SERVICE
TEST/SERVICE:
TESTPRINT
TEST/SERVICE:
DATA DUMP
TEST/SERVICE:
MEMORY RESET
TEST/SERVICE:
LSS TEST
TEST/SERVICE:
CMD LANGUAGE
LSS TEST:
LSS AUTO
CONFIG:
RFIDLABEL
TESTPRINT:
CONFIG
TESTPRINT:
TEST LABELS
TESTPRINT:
FORMAT
TESTPRINT:
PAGE
TESTPRINT:
UDC
CONFIG:
HW
CONFIG:
SW
TEST LABELS:
PITCH
FORMAT:
ALL
PAGE:
ALL
UDC:
ALL
TESTPRINT:
FONT
FONT:
ALL
ALL:
PRINT FORMATS
ALL:
PRINT PAGES
ALL:
PRINT UDCs
ALL:
PRINT UDFs
LSS AUTO:

MEMORY RESET:
CONFIGURATION
MEMORY RESET:
ALL
DATA DUMP:
YES
DATA DUMP:
NO
CMD LANGUAGE:
DSim
CMD LANGUAGE:
ZSim
CMD LANGUAGE:
IPL
LTS:
LTS ADJUST
LTS:
LTS TEST
LTS:
LTS VALUE
LTS VALUE:
10
REMOVE LABEL
ENTER TO STOP
REMOVE LABEL AND
PRESS ENTER
PRINT DEFS:
LTS
SENSITIVITY 10
OUT OF 9-10
Only displayed if a paper sensor is installed.