User’s Manual of netMod Network Termination Unit
Malfunction Possible Cause Correcting Action
You have a device that
supports the CLIP service
connected to the analogue
port, but the service does not
work.
Your device does not
recognise the CLIP
information.
• Be sure that the CLIP
service has been activated
by the operator.
• Be sure that your device is
working with FSK signalling.
• Raise the level of transmitted
signal using the command
AT/CLIPLEVEL=10.
You get overcharged when
you are connected to the
Internet Service Provider.
Incompatibility on the
negotiation process
between the ISP
equipment and the
netMod, when using
the second
B-channel.
• If you are not a ML-PPP
subscriber at 128Kbps, be
sure that you have not the
ML-PPP service activated on
netMod. At the selection of
Extra Settings, give the
command b40.
• Ask from the operator to
activate the AOC-D service
and then check the charge
metering using the AT
Commands
ats89=4 and
atch?
8
To Next Page
Loading...
