Invacare G50 - Page 45

Invacare
®
- G50
SERVICE INSTRUCTIONS
45
• Loosen and remove the fixation bolts of the
drive unit on both side with the Allen key 8
mm and socket spanner 17 mm.
• Loosen and remove the fixation screw of the
ground lead (1) with the Allen key 5 mm and
the open-end spanner 10 mm.
• Cut the cable binder (1) of the motor cable
with the pair of side cutters.
• Disconnect the plug-in connections (2) of the
motor cable at the power module
• Pull off the protective cap (1) of the
declutching bowden cable, or cut it off with the
side cutters.
• Loosen the fixation screw of the adjustment
sleeve (2) of the declutching bowden cable
with the small, flat screwdriver and the open-
end spanner 6 mm. Pull off adjustment
sleeve.