10.12
. Generally: Do I have with each configuration (Virtual com port) on different
configure?
configured only on the
have to install the
-Address has to be the same, so that all
alled COM-Ports haven further function.
nnect the Ethernet-
net. Afterwards you have also Router access over
d Device manually).
ally: subnet mask"?
Virtual COM-Port driver use the
ask.
nerally: sed mode RS232/485 possible? How does one switch
d RS485? Do the two modes run over the same DB9
switched between these modes. RS232 and RS485
ivers within the devices. But there are separate
rally: her232 can be managed with one workstation?
onverter (256 Com-Ports are possible but Com1
.
e of the ipEther232 indicated in the device
er232 is not recognized in the device
a virtual interface and not around a physical
ally: via Internet?
s the access possible to the serial device over
the local Ethernet. The TCP/IP protocol is used for it. TCP/IP forms the
basis of the Ethernet.
8. Generally: Is it possible to build with only 2 wires communication between the
RS485 interface of the ipEther232 and serial device on?
It is possible. Please look for this in our manual in the section RS485 as a 2
wire solution.
9. Generally: Are there 2 wire solution for the ipEther232 with RS232 interface also?
Yes. Only pin 2 (RXD Receiver Data), pin 3 (TXD Transmit Data) and mass
(GND) are needed. In addition it can be necessary to activate of
"NoModemSignals" in the Configtool. This can take place alternatively also
via durable bridging of pin 4 (DTR Data Terminal Ready) and pin 6 (DSR
Data Set Ready). For Pin allocation, please see the manual.
10. Generally: Why doesn't the ipEther232 function with 1200 baud?
The ipEther232 supports the speeds of 2400-115200 Baud. If you need
1200 Baud, contact us please.
11. Generally: Which supply voltages are offered for ipEther232?
9V DC, 18-36V DC, 18-27V DC
Other tensions on request.
FAQ’s
1
workstations the IP to again
No, the IP of the Serial-Ethernet-Converter must be
first installation. But for any further Workstation you
Virtual COM-Port driver. The IP
already inst
2. Generally: Does ipEther232 function over routs?
e first configuration you have to coYes, but for th
Converter to the own Sub
the Configuration-Tool (Ad
3. Gener Where can I configure the "
That is not necessarily, because the
Network-environment standard gateway and subnet m
4. Ge Is alternately u
between RS232 an
Port?
be Alternate is not to
have different bus dr
devices and order numbers.
5. Gene How many ipet
Up to 254 Seral-Ethernetc
and Com2 are physically already present)
6. Gen Why isn't the serial interfacerally:
manager?
The serial interface of the ipEth
s manager, because it concern
COM interface in the PC.
7. Gener Can serial devices be used with ipEther232 also
Yes, the ipEther232 make
Änderungen vorbehalten Stand 09.09.05
ipcas GmbH ipEther232 V11.01 Seite 146 von 150
To Next Page
Loading...