S103 Subnet Mask
Default 255.255.255.0
AT&W
the S103 register, you can set the Subnet Mask. The Subnet Mask only needs
be entered if the IpEther232.Modem is to connect to another subnetwork. In
). Please note: The IP address also defines the network class.
.
hey can only be extended "towards the right".
S104
not be
S110-119 Valid IP Addresses
Range xxx.xxx.xxx.xxx
Default 0.0.0.0
Store in permanent memory AT&W
In register 110 to 119 IP addresses can be set for which a call is accepted. For
reading and writing the AT command ATR had to be used. If no register contains
an IP address, all calls are accepted.
If a call is not accepted by a modem, the "Access Denied“ message is shown.
6.11 Result Code
System return code as a character string or digits (see AT command ATV), if not
suppressed with ATQ1.
Range xxx.xxx.xxx.xxx
Store in permanent memory
In
to
this case enter the Subnet Mask for the subnetwork where the ipEther is located
(e.g. 255.255.255.0
This results in a Default Subnetmask (e.g. 255.255.0.0 for a Class B network)
T
MAC – Address
Range 00:09:8E:xx:xx:xx
This register contains the Mac address of the network interface, which can
changed.
Char string Digit Definition
OK 0 Command line processed
CONNECT 1 Successful connection setup
RING 2 Incoming call
NO CARRIER 3 No connection established or inactivity
timer expired
ERROR 4 Error in command input
NO DIALTONE 6 No Ethernet connection
BUSY 7 Dialed line busy
ACCESS DENIED 8 Call rejected due to failed password
authentication
PASSWORT 11 Password OK
WRONG PASSWORT 12 Wrong password
Änderungen vorbehalten Stand 09.09.05
ipcas GmbH ipEther232 V11.01 Seite 78 von 150
To Next Page
Loading...