Chapter 3: Commissioning
3.1 Installation
Connect the device to the mains. The "Power“ signal and the flashing "System“
LED indicate that ipEther232 is ready for operation.
ipEther232 is connected to the network via an RJ45 socket.
The "Link LAN“ LED (connection) indicates the connection to the LAN.
If this is not the case, check the netwok connection or network line.
The enclosed CD contains a driver set-up program and the configuration tool.
The driver runs on all Windows NT based operating systems, therefore Windows
NT with SP5, Windows 2000 and Windows XP.
All Applications are based on the Microsoft .Net Framework 1.1. If .Net is not jet
installed on your Machine - just get and Install the DotNet framework 1.1.
Here is the URL:
http://msdn.microsoft.com/netframework/downloads/updates/default.aspx
(ca.23mb)
If you don't have an internet connection please install it from cd.
In addition the Datebase Application needs the "Microsoft Data Access
components 2.8" if this is not already installed on your Computer:
http://msdn.microsoft.com/data/mdac/downloads/default.aspx (ca.5mb)
If you don’t have installed this and you want or need it please look on our
driver cd.
No PC reboot is necessary after installation. The configuration tools starts
automatically after installation.
For later configuration sessions the program is included in the "Program files -
ipcas GmbH – ipEther Products“ folder.
Änderungen vorbehalten Stand 09.09.05
ipcas GmbH ipEther232 V11.01 Seite 20 von 150
To Next Page
Loading...