IpCAS ipEther232 - Datacommunication Information

See IEC 60870-5-1 IEC 60870-5-2
GW Source: Number
Number: 0
er when receive data from RS 232 line. Close the TCP
nnection with Time Out – gwidleto;
1 Connect to the Server when DSR is On, close the TCP connection when DSR is
ff;
2 en received RI signals, close when DCD is Off (only
th modem)
Status:
- Connect to the Serv
Co
-
O
- Connect to the Server wh
wi
Free Tx Bufer, Free Rx Buffer, Modem signals
Free Tx Buffer: 0h … 3000h
Free Rx Buffer: the range is - 0000h … 3000h
Modem Signale: DSR, CTS, DCD and RI
UART Status:
the range is - 000
Error Code
Error Codes:
- Ov
8 - Br
Note 1: des – TelNet Server or TelNet Client
ter remoteip is 0.0.0.0, then is activated TelNet Server
possible the Telnet clients to open one TCP connection for
mmand channel and two TCP connections for Data channels at the same
me.
eter remoteip is x.x.x.x then is activated TelNet Client Mode.
r232.TelNet opens the TCP connection with remote server
el. It is possible the Telnet client to open one TCP
channel at the same time.
Note 2: Whe the fo the xit” command.
ipEt w values are set.
Para , tcptimeout, portdata, remoteip,
Note 3: The valid va eters rxdtimeout and chartimeout are rate frequency
to 10 ms.
- rx
- ch , 10, 20, 30...250 ms
1 - Frame Error
2 - Parity Error
4 errun Error
eak
ipEther232.TelNet works in two mo
(Gateway Mode).
1). When the parame
ode. In this mode isM
oC
ti
2). When the param
n this mode ipEtheI
(remoteip) for Data chann
nnection for Commandco
n llowing parameters are changed then must use “e
her.Telnet makes Reset and the ne
meters: subnetmask, gateway
remoteport, gwsource
lues for the param
dtimeout - 1
artimeout - 0
0, 20, 30, …65530 ms
5.5 Datacommunication
Änderungen vorbehalten Stand 09.09.05
ipcas GmbH ipEther232 V11.01 Seite 49 von 150