S99 Time Distance between rings
AT&W
ermissible time distance between
two received rings. The default value of 7.5 seconds applies to most cases.
S100 IP Address
Range xxx.xxx.xxx.xxx
10.10.5.1
nent memory AT&W
In the S100 register, you can set your own IP address. The factory-set value of
10.10.5.1 mus to your network.
Bear in mind, when mo i , but
depends on the networ follows
the familiar syntax (e.g. 192.168.31.5).
S101 Default Gateway
Range
Default
Store in pe
In the S101 register, you can set the D u enter the
Gateway IP address, if connections to other subn orks are to be established.
S102 Auto Remote
Range
in perm
e S102 register, you can set the Auto Remote Partner. Enter the IP address
n partner" for which a connection is to be established
automatically (Leased line). After a connection break-off there is an automatic
attempt at restoring the connection. The connection set-up and take-down can be
controlled via DTR (see AT&D).
Range 10..255
Default 4 (4 seconds)
Store in permanent memory
In the S99 register, you can set the maximum p
Default
Store in perma
t be adjusted
dify ng this va cannot be chosen flue, that it reely
k address of the TCP/IP network. The input format
xxx.xxx.xxx.xxx
0.0.0.0
rmanent memory AT&W
efault Gateway. Here yo
etw
xxx.xxx.xxx.xxx
Default 0.0.0.0
Store
anent memory AT&W
In th
of the "communicatio
Änderungen vorbehalten Stand 09.09.05
ipcas GmbH ipEther232 V11.01 Seite 77 von 150
To Next Page
Loading...