EasyManua.ls Logo

IpCAS ipEther232 - Password Protection Setup

IpCAS ipEther232
150 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Enable the password configuration mode:
Enter the ATP master password to enter the configuration mode. The default
master password is "000000“
ATP000000
Set up and change the passwords:
To change the master password, enter ATZ=“new master password". 9 more
passwords can be configured here (ATZ1...ATZ9).
ATZ1=ipether
Each password consists of a maximum of 8 characters (additional characters are
ignored). The password is not case-sensitive (special characters are allowed).
Enter ATZ? or ATZ1?...ATZ9? to read out all the passwords
Enable password protection:
Register 81 allows you to enable and disable the password protection.
(only in the password configuration mode)
ATS81=1 enable password protection mode
ATS81=0 disable password protection
Password blocking time:
Register S82 enables the setting of a password blocking time.
After three incorrect password entries, the modem waits for the blocking time,
before a new password query is allowed.
ATS82=120 The blocking time is 2 minutes
Valid IP addresses:
The password configuration mode allows the configuration of ten IP addresses,
for which calls are accepted. (ATR0....ATR9). If this list is empty, calls are
accepted from all partner modems.
ATR1=192.168.10.12 Calls are accepted
Save changes:
All changes only take effect after they have been saved.
The AT&W command starts the saving process.
AT&W
If the master password has been forgotten, the device must be sent in.
If the settings are not saved, all changes are lost, once the ipEther232.Modem is
disconnected from the power supply.
Quit the password configuration mode:
Enter ATP to exit the configuration mode.
ATP
The dial-up to a password protected ipEther232.Modem returns the message
"PASSWORD:“
To set up a connection, the master password or one of the 9 additional
passwords (if defined) must be entered.
An incorrect entry leads to the "WRONG PASSWORD“ message.
If a call from an IP protected modem is not accepted, the message "ACCESS
DENIED“ is issued.
Änderungen vorbehalten Stand 09.09.05
ipcas GmbH ipEther232 V11.01 Seite 62 von 150

Table of Contents