IpCAS ipEther232 - Page 70

AT&H alf Duplexcontrol for RS485 as 2 wire solution.
hile sending is the reception of data suppressed.
T&H1 Half Duplexmodus on
AT&H0 Half Duplexmodus off (Fullduplex; default)
AT&P eave passwordconfigurationmodus (see ATP).
AT&R
AT&V ead out and display current configuration.
T%V Display Firmware-Version (corresponds ATI3).  AT%V
AT&W flash
AT&Z passwords (master password and connectionpasswords).
ee ATZ) (only in passwordconfigurationmodus (see ATP) availiable)
The following registers were not reset:
Register Definition
S1 Number of rings
S31 Baud rate
S32 Parity
S33 DataBits
S34 StopBits
S81 Password protection
S99 Time between two rings
S100 Own IP
S101 DefaultGa teway
S103 Subnetmask
S104 MAC-Addresse
S110-119 Valid IP addresses
H
W
 A

 AT&H? Read out Half Duplexmodus
L
Give out a chart of all setted IP-addresses which receiving calls.
(see ATR) (only in passwordconfigurationmodus (see ATP) available)
R
A
Store current configuration in
Give out a list of all
(s
Änderungen vorbehalten Stand 09.09.05
ipcas GmbH ipEther232 V11.01 Seite 70 von 150