2: ERR_RXDBufferOverrun
The UART (RS232) receivebuffer is overruned.
4: ERR_NICOverrun
The NIC (Network Interface Controller) receivebuffer is overruned.
5: ERR_SETUP_BAUD,
6: ERR_SETUP_PARITY,
7: ERR_SETUP_DATA
The UART (RS232) parameter is incorrect. Please use the configurationtool
to set the correct RS232 parameters.
9: ERR_UART_OVERRUN
Overrun Error Bit from received controlregister (UART) would be ignored.
10: ERR_UART_FRAME
Framing Error Bit from received controlregister (UART) would be ignored.
18: ERR_NIC_INTERNAL
The DMA operation on the networkcontroller (NIC) could not lead through.
23: ERR_PPP_BUFFER_OVERRUN_ETH
The Ethernet IP buffer is full. The incoming IP Packet has been ignored.
24: ERR_PPP_BUFFER_OVERRUN_PPP
The PPP (RS232) IP buffer is full. The incoming IP Packet has been ignored.
25: ERR_PPP_INVALID_MESSAGE
A wrong LCP or IPCP information would be received. The PPP Packet has
been ignored.
(Defaults for the PPP Protocol – RFC1661, RFC1662, RFC1332)
28: ERR_PPP_CRC
A PPP Packet with wrong checksum (FCS) has been received. This Packet
has been ignored.
31: PPP_IPCP_UP
authentication has been lead through. The PPP
2: PPP_IPCP_DOWN
n has been disconnected.
nnect. In this case the
aultparameter would be loaded. Please execute the configurationtool
rreset because of „Watchdog Timeout“
35: ERR_NORMAL_POWER_UP
Processorreset because of „Watchdog Timeout“
36: ERR_MCLR_FROM_SLEEP
Processorreset because of „SLEEP“
37: ERR_BROWNOUT_RESTART
Processorreset because of main disturbances
The LCP und IPCP
connection has been established.
3
The PPP connectio
33: ERR_INVALID_CONFIG
A invalid parameter would be established after the co
def
again. If the MAC Address does no more agree please contact your vendor's
customer service
34: ERR_WDT_TIMEOUT
Processo
Änderungen vorbehalten Stand 09.09.05
ipcas GmbH ipEther232 V11.01 Seite 93 von 150
To Next Page
Loading...