Version 1.0 SERIES 3000
IRIS OWNER’S GUIDE B-3 Appendix B
•siintr: sitab.b_active == 0
•siintr hard error NN: “error” block: NN cmd: command
C. The following messages occur in non-interrupt mode and could mean
a faulty controller, a bad set of disk cables, or incorrect jumpering of
the controller.
•sicmd: timeout wait for status
•sicmd: timeout waiting for cmd “command” to complete
•sicmd: status error: “error”
•sicmd: error stat “status” err “error” iostat “iostatus”
D. The following error indicates a recoverable problem with the disk.
This message may appear when there is a bad track on the disk. If
this message appears repeatedly, contact Customer Service through
the Geometry Hotline (see Chapter 1).
•soft error “error” on block NN
B.1.3 Tape Drive Messages
A. The following are general messages for the tape drive.
•qic0: no cartridge in drive
Cartridge isn’t inserted properly.
•qic0: unit not ready
•qic0: write protected
Dial on the cartridge needs to be twisted to enable writing on the
tape.
B. The following error message indicates that the tape drive has no
power or that the control cable for the tape drive is disconnected or
reversed.
•qic0: can’t get status during init
C. The following error messages indicate that there is a problem with
the tape drive that inhibits its operation. The operation using the
tape drive must be restarted.
•qic0: couldn’t start
•qic0: hard error during “Read or Write” status= XX
•qic0: “command” failed
To Next Page
Loading...
General