Version 1.0 SERIES 3000
5. IRIS 3010 System Administration
This chapter contains operation and configuration procedures for the IRIS 3010.
Topics covered are shown in the table below. At this point, it is assumed that
you have installed and booted the IRIS (see Chapters 2 and 3).
5.1 Host Software Installation
5.2 Operation
5.2.1 Connecting to the Host
5.2.2 Issuing Commands to the Terminal Emulator
5.2.3 Running a Demonstration Program
5.2.4 Shutting Down the IRIS Terminal
5.2.5 Boot Failure Recovery
5.3 Software Configuration
5.3.1 Configuration Tools
5.3.2 Configuring the Startup Environment
5.3.3 XNS Configuration
5.3.4 TCP/IP Configuration
5.3.5 Miscellaneous Un i x Configuration
5.1 Host Software Installation
This section contains instructions for installing the host-resident IRIS 3010
support software in a VAX Un i x 4.2BSD environment. For an IRIS workstation
System V environment, install the software according to Section 4 of Installing
Software Updates. The entry name for the workstation host-resident software is
host. Instructions for installing host software in other environments are
shipped with the software.
The software is delivered on a 1600 bpi half-inch magnetic tape in tar(1) format.
The software can be stored anywhere on the host file system. The procedure
below assumes that the distribution software is installed in a directory called
/usr/iris.
To install the host software, follow these steps:
1. Log in to Un i x from a terminal that is already attached to the host.
To Next Page
Loading...
General