B-4 IRIS OWNER’S GUIDE
SERIES 3000 Version 1.0
Appendix B
8.1.4 Floppy Controller Messages
A. The following are general messages.
•mf0: write protected
•mf0: disk formatted
•Reading on mf0
•Writing on mf0
B. The following message indicates a problem with the floppy disk
controller.
•mf0a: hard error, cmd=’command’,error=’error’
B.2 System Software Messages
A. The following error messages indicate a problem with the Ethernet
hardware or software.
•nxpresent cleared
•xns_ttstart
B. The following message occurs while the system is booting. This
message indicates that the system attempted to configure a disk
drive with no entry in the bdevsw[] array (the array of block devices).
The system was incorrectly configured.
•getmajor
C. The following messages indicate that there is a problem with the
buffer cache/inode tables.
•devtab
•no fs
•no imt
D. The following message indicates that the init process was killed.
If the process was killed through a user program or the shell kill
command, then this message may not reflect a problem. If the init
process was killed during the boot procedure, then this message
indicates a problem with the root file system.
•init died!
To Next Page
Loading...
General