To remove file, enter:
irsh rm file
Conguration from a Unix Host
After the distribution software has been installed on the Un i x host, you can
use this procedure to configure the IRIS 3010 from the host:
1. Boot the IRIS 3010 from its local disk and log in to the host (see
Section 3.2).
2. Change directories to /usr/iris/c.
$ cd /usr/iris/c
3. Edit the configuration files as described in the remainder of this
chapter.
4. Transfer the files to the IRIS 3010 by invoking the iftp program for
each file. To transfer all files in a single step, use the makefile
argument install-config-files.
$ make install-config-files
5.3.2 Conguring the Startup Environment
You can configure the startup environment on the IRIS 3010 in these ways:
1. Custom-configuring the terminal emulator program, wsiris.
2. Causing the window manager to start automatically during
bootstrap.
3. Installing your own startup program.
The next three sections describe these procedures.
Terminal Emulator Conguration
The terminal emulator program, wsiris, is customized through the file .wsirisrc.
The working copy of .wsirisrc is stored on the IRIS 3010’s hard disk. The file
contains any number of the option flags listed below, separated by whitespace
(spaces, tabs, and newlines), and possibly followed by a hostname.
Arguments to individual option nags are separated from their options by
whitespace.
5-10 IRIS OWNER’S GUIDE
SERIES 3000 Version 1.1
IRIS 3010 System Administration
To Next Page
Loading...
General