6
Keywords
• Door sensor contact: electronic device made of 2 contacts and installed in the door frame, that
allows x1R Smart to know if door is ajar or open. It is possible to install it in the lock side or in
the hinges side of the door.
• Door status: it defines the “door condition”, open or closed, which can be as follows.
a. Door closed and safe: latch and bolts fully extended (shot-out).
b. Door closed but not safe: only latch inserted.
c. Door opening or tampering: when bolts are moving backwards.
d. Door fully open: latch and bolts fully backward (withdrawn).
• Door status relay: it is a relay, built-in into the x1R Smart electronic board, that allows to send
outside the Door status signal: open or close. It can be used for example in a home automation
system, to switch on the light when door opens, or to activate an alarm system when door closes.
It needs to operate the DC external power supply by Cable gland spring.
• External control module: it is an accessory connected by cable to the lock electronic board. It is
installed in the external side of the door. It embeds an RFID module, for Cards reading purpose,
and a Bluetooth module for the Argo app interface. It can be supplied with keyboard, to
memorize PIN as Credential to open the door.
• First Person In: function that, when enabled, allows the first user that enter a door, presenting
a valid credential, to activate the Scheduled Passage Mode.
• Free Mode: setting the Passage Mode in Free, the lock withdraws the bolts and holds back the
latch. In this mode the door is always opened for any user who wishes to gain access, without
the use of authorized credentials.
• Hidden External Reader: it’s a Bluetooth and RFID reader, like the External control module (with
no PIN option), that can be fit inside the door in order to have from the outside a clean door
surface solution (called in jargon "clean facade door"), so that, from outside, nothing is visible.
• Internal control module: it is an accessory connected by cable to the lock electronic board. It is
installed in the internal side of the door. By 2 buttons, allows the door opening and closing. It is
not required if x1R Single Action version.
• Light Mode: setting the Passage Mode in Light, the lock withdraws the bolts, and keeps closed
only by the latch. Opening with authorized credentials withdraws only the latch, allowing energy
saving and less mechanical wear.
• Master Card: Cards used to program and manage the Access Control Device.
• Master Card Level: it is related to the number printed on each Master Card, belonging to the
same System Code, that can be 1, 2 or 3.
• Master Card Set: set of three Master Cards numbered from 1 to 3, belonging to the same System
code. The Master Card of higher number disable the Master Card of lower number.
• Optoisolated input: it is an electrical input made by a component that transfers electrical signals
between two circuits, keeping them isolated between each other. In this way issues to one of
the circuit, such as electrostatic discharges, voltage spikes or short circuits, does not affect the
other one.
• Passage Mode: function that allows the door to be always open for any user who wishes to gain
access, without the use of authorized credentials. On x1R Smart this function can be set in Free
or Light Mode.
To Next Page
Loading...
Need help?
General
